guns are normal and normal people build guns

One of the ordinary modes, by which tyrants accomplish their purposes without resistance, is, by disarming the people, and making it an offense to keep arms. 

Joseph Story, Associate Justice of the Supreme Court of the United States



Build legal unserialized, unregistered, untraceable EBRs and more without Big Brother knowing.

Ghost Gunner 3



Free Shipping

Ghost Gunner 3 is a general purpose CNC mill that gives you the ability to finish 80% receivers and frames with ease, in the comfort of your own home.

Ghost Gunner 3 is a complete redesign based on the successes of the GG2. It uses a milled, precision unibody frame for sharply improved squareness and rigidity. Optical limit switches and pre-loaded, self-aligning ballscrews allow it to deliver advanced positional accuracy.

GG3 incorporates a custom motion-control board with a closed loop, digital VFD controller. The machine accepts g-code from most CAM post-processors, and supports tool diameters up to 8 mm (~5/16”).

Included with the GG3: A DD USB with all our latest software. ER-11 collet nut, 5/16″ allen wrench, 3mm ball-end allen wrench, 12mm wrench, 17mm wrench, 6′ USB A-B cable, 6′ three-prong power cable. Laptop not included. Shipping is a flat rate of $150 in the United States. The machine dimensions are: 270mm / 425mm / 380mm.

System Requirements:
Windows 7+, Mac OSX 10.13+
42 lbs.
X/Y/Z Travel:
89/242/79 mm (Double GG2 build volume)
X/Y/Z Interior Clearance:
116/299/16 mm, (Measurements w/ cover installed)
Peak Spindle Power:
375 W (Overload protection prevents exceeding)
Continuous Spindle Power:
190 W (Long-term average, temperature limited. Can be exceeded)
Spindle Speed:
3000-9000 rpm (Variable, closed Loop. Can apply full power at any rpm)
Max Linear Velocity:
2600 mm/s (260% faster than GG2)
Max Linear Acceleration:
250 mm/s^2 (8 times more than GG2)
Spindle Runout:
0.0009 in (Measured on tapered collet, 1mm from tip)
T-Slot Spacing:
40 mm (Center-to-center)
Table T-slots:
2 QTY (Compatible with 20 mm T-nuts)
Max. Tool Length w/o Crashing:
3.25 in (Maximum tool length that will not crash during homing)
Collet System:
ER11 – (Accepts tools up to 8 mm)
Operating Temperature:
0-40 C (To prevent overheating)
Relative Humidity:
0-70% (To reduce oxidation)
USB Current:
95 mA (Can plug into unpowered hubs)
Line Power:
500 W
Input Voltage:
90-132 or 180-264 VAC (Selector switch)
Input Frequency:
47-63 Hz

Customers Also Viewed

From the same Collection